terewmj.blogg.se - Anker usb-c to ethernet adapter manual

Fortunately enough, with the Anker AK-A7522012, the problem that we just described is about to become a thing of the past for you. The above disclaimer applies to any property damage, equipmentįailure, liability, infringement, or personal injury claim arising out of or inĪny way related to your use or application of the content, whether such claim isįor breach of contract, tort, negligence or any other cause of action.It's always a bummer when you purchase a top-of-the-line, nay, state-of-the-art desktop computer or a gaming laptop in order to enjoy the latest triple-A titles or do some 3D modeling but, despite the exorbitant amount of money that they charge you for their hardware, the people behind it didn't do you to courtesy of equipping the computer with a sufficient number of ports. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING

RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITSĪUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. DAKTRONICS DISCLAIMS ANYĪND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ALL WARRANTIES,ĮXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT

Type in the desired IP Address for the computer or select Obtain IP Address Automatically for DHCPĭAKTRONICS DOES NOT PROMISE THAT THE CONTENT.

Make note of the current IP settings for the computer.

Right Click on the appropriate adapter ( Local Area Connection for direct connect to computer or correct USB to Ethernet adapter) then click on Properties.

Network and Sharing Center on the search results on the left. OK once the information has been entered.Ĭlose to close out the Local Area Connection Properties window.

Note: The subnet mask should be the same between the computer and the display.

Tab Key on the keyboard after typing the IP Address and the Subnet Mask should populate automatically.

Note: The IP Address for the computer should be similar to the display IP Address, but NOT the same.

Type in the desired IP Address for the computer or select Obtain IP Address Automatically for DHCP.

Make note of the current IP settings for the computer.

Internet Protocol Version 4 then click on

Right Click on the appropriate adapter ( Local Area Connection for direct connect to computer or correct USB to Ethernet adapter) then click on.

Open Network and Sharing Center when the window opens.Ĭhange Adapter Settings in the left toolbar. Click on the network icon at the bottom right of your computer screen.If display is not using the default IP Address, set computer's IP Address to a static IP Address similar to the display's controller.If using the default Daktronics IP Address of 172.16.192.25 on the display, use the following IP Address of 172.16.192.20 and a Subnet of 255.255.0.0 on the computer.Note: (If display's IP Address is not known, cycle power and watch the start up sequence for the IP Address of the controller):.Change IP Address on computer Local Area Network adapter or USB to Ethernet adapter to a similar IP Address.